Total watts = W/m x length. Then size the driver so that load is no more than 80% of its rating. Enter your tape, length and voltage to get the minimum driver size, a standard size to buy and the feed points you need.
Suggested standard driver
60W
How the calculation works
Total length = run length x number of runs
Total load (W) = W/m x total length in metres
Minimum driver (W) = load / 0.8, rounded up
Standard driver = smallest of 16, 20, 30, 60, 75, 96, 100, 150, 200, 288W that fits
Current (A) = W / tape voltage
Feed points per run = run length / 5 m (24V) or 2.5 m (12V), rounded up
Why 5 m reels?
Tape light is sold in 5 m reels because voltage drop makes the far end of a long run dimmer and warmer than the end with the power feed. Keeping each section to about 5 m and feeding each one in parallel keeps the light even. Read the full explanation in our LED tape light voltage drop and driver sizing guide. The 2.5 m figure for 12V tape is a typical guideline; always check the spec sheet.
Multiply the tape power in W/m by the total length in metres to get the load, then divide by 0.8 so the driver runs at no more than 80% load. For example, 8 W/m x 5 m = 40W, so you need at least 50W and a standard 60W driver.
How far can I run 24V LED tape from one feed point?
As a typical guideline, about 5 m per feed point on 24V tape (about 2.5 m on 12V). Check the spec sheet for your tape. Longer runs need extra feed points wired in parallel to avoid dimming at the far end.
What does Class 2 mean for LED drivers?
Class 2 drivers limit output power, and most are limited to about 100W per output. Above that, split the load across several drivers or outputs.
Where can I buy LED tape lights and drivers in Edmonton?
LitesGo, 4914 89 St NW, Edmonton, (587) 701-5969, ships across Canada. Browse LED tape lights, NEXLEDS strip lights and tape light drivers on litesgo.com.
Need help sizing a tape light job?
Talk to LitesGo, 4914 89 St NW, Edmonton, AB. Call (587) 701-5969.