Outdoor Wall Lights Guide: Sconces, Cylinders and Wall Packs

House entrance at dusk with two black outdoor wall sconces

Use a residential sconce for entrances and decorative accent light, an up/down cylinder to wash a wall with light above and below, and a commercial wall pack for building perimeters, loading areas and security lighting. Whichever you choose, confirm the fixture is wet-rated, and pick a full cutoff design where glare and light spill matter.

What is the difference between a sconce, a cylinder and a wall pack?

All three mount to a wall, but they are built for different jobs. The table below summarizes where each one fits.

Type Best for Light pattern Typical setting
Residential sconce Entrances, garages, patios, decorative accent Mostly downward or all-around, softer output Homes, townhouses, multi-family entries
Up/down cylinder Modern facades, wall washing, accent Light above and below the fixture Homes, condos, small commercial buildings
Commercial wall pack Perimeters, doors, loading docks, yards Forward throw over a wider area Warehouses, shops, industrial and commercial sites

Browse our outdoor LED wall sconces for residential and light commercial use, and our LED wall pack lights for building perimeters.

When should you choose an up/down cylinder light?

A cylinder gives a clean architectural look and puts light on the wall surface above and below the fixture. It suits modern entries, garage fronts and balconies, and works well in pairs on either side of a door.

Check the beam spread and the distance between fixtures. Cylinders placed too far apart leave dark gaps along the wall.

When is a commercial wall pack the better choice?

Wall packs throw more light outward and cover a larger area. They are the usual choice for the back of a building, service doors, loading areas and anywhere you need steady security lighting. Many models offer selectable wattage or colour temperature and an optional photocell.

If you are replacing older metal halide units, our LED wall pack guide covers sizing and replacement in detail.

How high should an outdoor wall light be mounted?

Mounting height depends on the fixture, so follow the manufacturer's installation instructions first. As general guidance only:

  • Entry sconces are commonly mounted around eye level, often roughly 1.5 to 1.8 m (5 to 6 ft) above the finished floor or landing. Position them beside the door, not above it, to reduce glare.
  • Cylinders are often mounted at a similar height beside doors or garage openings.
  • Wall packs are usually mounted higher on the building, above reach, with the exact height set by the fixture and the area to be lit.

Confirm requirements with the Canadian Electrical Code and your local authority having jurisdiction (inspector).

What wet rating does an outdoor wall light need?

Any fixture exposed to rain or snow should be rated for wet locations. Fixtures that are covered, such as under a deep soffit, may be able to use a damp rating, but a wet-rated fixture is the safer choice in Canadian weather. For a plain-English explanation of IP numbers, see our IP ratings guide.

Do you need a photocell or motion sensor?

  • Photocell: turns the light on at dusk and off at dawn. Good for entrances and building perimeters.
  • Motion sensor: raises or turns on the light when someone approaches. Good for side yards and back doors.
  • Both together: a common approach is a low level at night that brightens on motion.

Check the product page to confirm whether a sensor is built in or sold separately.

What is a dark-sky or full cutoff fixture?

A full cutoff fixture sends no light above the horizontal. It points the light where it is needed, reduces glare and keeps light off neighbouring properties and out of the night sky. Look for shielded or downward-facing designs, and choose a warmer colour temperature for residential areas. Our colour temperature guide explains the options.

Where can you find branded outdoor wall sconces?

We are an authorized distributor of Dainolite. See the Dainolite outdoor wall sconces for decorative options, and call us if you need help matching a style across a project.

Frequently asked questions

Can I use an indoor sconce outside?

No, unless it is rated for the location. Outdoor fixtures exposed to weather need a wet rating. Check the product page for the rating before you install.

What is the difference between a sconce and a wall pack?

A sconce is a decorative fixture for entrances and patios. A wall pack is a commercial fixture built to cover a larger area for security and perimeter lighting.

How high should I mount an entry light?

Many installers mount entry sconces around eye level beside the door. Follow the manufacturer's instructions and check local code and your inspector.

Do I need a photocell on an outdoor light?

It is not required for every fixture, but it saves you from switching lights on and off by hand. Many entrance and perimeter lights use a photocell, a timer or a motion sensor.

Are outdoor LED wall lights dimmable?

Some are. Check the product page for dimming information, and confirm that your dimmer and the fixture's driver are compatible.

Need help choosing outdoor wall lights for a building or project? Contact the LitesGo team or call (587) 701-5969. We are at 4914 89 St NW, Edmonton, AB T6E 5K1, and in-stock items usually dispatch in 1-2 business days anywhere in Canada.